Bodywork

Removing Plastic

Removing the fairing can be a quick and simple task, especially when you've done it 1000 times.

For the seat unit:

1. Remove the rear seat pad.
2. Undo two allen screws where the pod meets the tank.
3. Undo two allen screws hidden underneath the back of the front seat pad
   (which also release the front pad).
4. Disconnect the rear bulbs.
5. Pull the whole lot up and backwards.

For the fairing lowers:

1. Undo the 3 screws on the mid panels (only the rear-most on each side is
   actually a screw. The others are quick release fasteners (quarter turn skrews)
2. Remove the Black plastic lugs near the radiator.
3. The side panels should now swing out.
4. Undo the 4 allen screws holding the lower to the bike. It is easier to get
   the lower off if you undo the 3 posidrive screws that hold the plastic that
   funnels air to the radiator.